Setting Up The Projector Network Environment ("Network" Menu); Setting A Password - Sharp Notevision PG-D45X3D Operation Manual

Setting up the Projector Network Environment ("Network" Menu)

1 Setting a Password

If you do not want others to change the setting
for the "Network" menu, set a password.
a Setting a Password
1 1
Select "Password", then press
or Q.
• The screen for entering the password
appears.
Setting the Password
Old Password
New Password
Reconfirm
Press P or R to set the fi rst digit
2 2
in "New Password", then press Q.
3 3
Enter the remaining 3 digits, then
press
To return to the previous digit, press O.
•
4 4
Enter the same password in
"Reconfi rm", then press
• The status for "Password" changes to
"Enable".
Note
• Once the password is set, you must enter the
password to change the "Network" menu
settings.
a Changing the Password
1 1
Select "Password", then press
or Q.
• The screen for entering the password
appears.
Pict. SCR
1
Password
2
DHCP Client
3
TCP/IP
MAC Address X X : X X : X X : X X : X X : X X
4
Projector X X - X X X X
SEL./ADJ.
Network
– – – –
– – – –
– – – –
.
PRJ Network Help
Disable
Off
ENTER END
2 2
Enter the password in "Old
Password" using P, R, Q and O,
then press
3 3
Enter the password in "New
Password" using P, R, Q and O,
then press
4 4
Enter the same password again
in "Reconfi rm" using P, R, Q and
O, then press
Note
• If you do not need the password protection
for the "Network" menu settings anymore,
press ENTER without entering the new
password in steps 3 and 4.
• To cancel the password settings, press
RETURN.
If you forget the password
If you forget the password, perform the
.
following procedure to delete it, then set a
new password.
On the projector, press
Note
• If ENTER is held down for more than 5
seconds, the operation buttons on the
projector will be locked. (See page 48.)
• You cannot use the buttons on the
remote control to delete the password.
Menu operation n Page
.
.
.
38
.
49