Signal Adjustment ("Sig-Adj" Menu); Adjusting The Computer Image; Resolution Setting; Signal Type Setting - Sharp PG-D3010X Operation Manual

Signal Adjustment ("SIG-ADJ" Menu)

1 Adjusting the Computer Image

If the optimum image cannot be obtained with
Auto Sync adjustment, use the SIG-ADJ function.
Selectable
items
Clock Adjusts vertical noise.
Phase Adjusts horizontal noise (similar to
tracking on your VCR).
H-Pos Centers the on-screen image by
moving it to the left or right.
V-Pos Centers the on-screen image by
moving it up or down.
Note
• To reset all adjustment items, select "Reset"
and press ENTER.
• The adjustable range of "H-Pos" (H-Position)
and "V-Pos" (V-Position) may vary depending
on the screen resolution of the computer.

2 Resolution Setting

Ordinarily, the type of input signal is detected and
the correct Resolution mode is automatically
selected. However, for some signals, the optimal
Resolution mode in "Resolution" may need to be
selected to match the computer display mode.
Note
• See "Checking the Input Signal" on page
for information on the currently selected input
signal.
Pict. SIG-ADJ
Clock
Phase
1
H-Pos
V-Pos
Reset
2
Resolution
3
Signal Type
4
Video System
5
Video Setup
Signal Info 1024 x 768
6
H 48.3
SEL./ADJ.
Description
46
SCR PRJ1 PRJ2 Net.
0
0
0
0
1024 x 768
Auto
Auto
0 IRE
kHz / V 60.0 Hz
ENTER END

3 Signal Type Setting

This function allows you to select the input signal
type RGB or Component for COMPUTER/
COMPONENT 1 or 2.
Selectable
items
Auto Input signals are automatically
recognized as RGB or component.
RGB Set when RGB signals are received.
YPbPr Set when Component signals are
received.
Menu operation n Page
Description
40
45