Connecting Rs-232C Port - Sharp Notevision PG-C30XU Operation Manual

Connecting the Projector
Connecting RS-232C
When the RS-232C port on the projector is connected to a computer with an RS-232C cable (null modem, cross
type, sold separately), the computer can be used to control the projector and check the status of the projector.
See pages 52 and 53 for details.
1 Connect the supplied DIN-D-sub RS-232C cable to the RS-232C port on the projector.
2 Connect an RS-232C cable (null modem, cross type, sold separately) to the other end of DIN-D-sub RS-
232C cable and to the serial port on the computer.
CAUTION
• Do not connect or disconnect an RS-232C cable to or from the computer while it is on. This may damage your computer.
• The wireless mouse or RS-232C function may not operate if your computer port is not correctly set up. Please refer to the
operation manual of the computer for details on setting up/installing the correct mouse driver.
• The arrows (→, ↔) indicate the direction of the signals.
• A Macintosh adaptor may be required for use with some Macintosh computers. Contact your nearest Authorized Sharp
Industrial LCD Products Dealer or Service Center.
Port
Computer RGB cable
QCNW-5304CEZZ
Computer audio cable
QCNW-4870CEZZ
2 RS-232C cable
(null modem, cross type, sold separately)
DIN-D-sub RS-232C
cable
QCNW-5288CEZZ
1 DIN-D-sub
RS-232C cable
E-14