Comtech EF Data XSAT-7080 Series Installation And Operation Manual page 43

XSAT7080 X-Band Transceiver
Remote Control
Arguments
for
Command
Command
or
(Instruction
Parameter
Response
Code and
Type
to Query
qualifier)
Rx Slope DSA= 3 bytes
Adjust
Reference REF= 3 bytes
Oscillator
Adjust
Cold Start CLD= 1 byte,
value of 0,1
Auto Fault AFR= 1 byte,
Recovery value of 0,1
Online N/A 1 byte,
Status value of 0,1
LNA Current LCS= 1 byte,
Source value of 0,1
Description of Arguments
Note that all arguments are ASCII
numeric codes between 48 and 57.
Command or Query.
Rx Slope Adjust, between 0.0 and 1.0.
Resolution = 0.1.
Example: DSA=0.3
Command or Query.
Ref Osc Adjust, between 000 and 255.
Resolution 001.
Example: REF=087
Note: REF cannot be adjusted when the XSAT
is locked to an external reference source.
Command or Query.
Cold Start, where:
0 = Disabled,
1 = Enabled
Example: CLD=1
Command or Query.
Auto Fault Recovery, where:
0 = Disabled,
1 = Enabled
Example: AFR=1
Query Only.
Online status, where:
0 = OFFLINE,
1 = ONLINE
Example: ONL=1
Command or Query.
LNA Current Source, where:
0 = Disabled,
1 = Enabled
Example: LCS=1
Response to
Command
(Slave to Master)
DSA= (message ok)
DSA? (received ok,
but invalid arg.
found)
REF= (message ok)
REF? (received ok,
but invalid argument
found)
REF* (message ok,
but not permitted in
current mode)
CLD= (message ok)
CLD? (received ok,
but invalid
arguments found)
AFR= (message ok)
AFR? (received ok,
but invalid
arguments found)
ONL= (message ok)
ONL? (received ok,
but invalid
arguments found)
LCS= (message ok)
LCS? (received ok,
but invalid
arguments found)
4-9
MN/XSAT7080.IOM
Query
(Instruction Response to Query
code and
(Slave to Master)
qualifier)
DSA? DSA=x.x
(same format as command
argument)
REF? REF=xxx
(same format as command
argument)
CLD? CLD=x
(same format as command
arguments)
AFR? AFR=x
(same format as command
arguments)
ONL? ONL=x
(same format as command
arguments)
LCS? LCS=x
(same format as command
arguments)
Revision 0