Electrolux EDE1074PDW User Manual page 10

10 electrolux
TIME
Use the TIME button to select the pro-
gramme duration after setting the TIME
programme. You can select a programme
duration from 20 min. to 3 hours in 10-mi-
nute steps.
1. Turn the programme selector to the
TIME programme.
2. Press the TIME button repeatedly until
the desired programme duration is
shown in the display, e.g.
for a programme of 20 minutes.
If the programme duration is not selected,
the duration is automatically set to 10 mins.
DELAY START
With the DELAY START button, you
can delay the start of a programme by
between 30 minutes (30') and a maxi-
mum of 20 hours (20h).
1. Select the programme and additional
functions.
2. Press the DELAY START button as
many times as necessary until the re-
quired time of the delay appears on the
display, e.g.
is to be started in 12 hours.
If the display is showing
you press the button again, the time
delay will be cancelled. The display will
show 0 and then the duration of the
selected programme.
3. To activate the delay timer, press the
START/PAUSE button. The amount of
time remaining until the programme is
set to start is continuously displayed
(e.g. 15h, 14h, 13h, ... 30' etc).
SETTING CHILD LOCK
The child lock can be set to prevent a pro-
gramme being accidentally started or a pro-
gramme in operation being accidentally
changed. The child lock function locks all
buttons and the programme knob. The
child lock can be activated or deactivated
by holding down the BUZZER
buttons simultaneously for 5 seconds.
– Before programme is started: Appli-
ance cannot be used
H if the programme
H and
and TIME
– After programme is started: Pro-
gramme in operation cannot be
changed
The icon appears in the display to indi-
cate that the child safety device is activa-
ted.
The child safety device is not deactivated
once the programme comes to an end.
If you want to set a new programme, you
must first deactivate the child safety device.
STARTING THE PROGRAMME
Press the START/PAUSE button. The pro-
gramme is started.
The programme phase is shown in display
by appropriate icons. From left to the right,
from drying ,anticrease
.
CHANGING PROGRAMME
To change a programme which has been
selected by mistake once the programme
has started, first turn the programme selec-
tor to " O" (OFF) position. The programme
is cancelled.
The programme can no longer be
changed directly once the programme
has started. If nevertheless there is an
attempt to change the programme on
the programme knob or if an function
button (excluding the BUZZER button)
is pressed, led above START/PAUSE
button starts flashing temporarily in yel-
low. The drying programme is not how-
ever affected by this (laundry protec-
tion).
DRYING CYCLE COMPLETE /
REMOVING LAUNDRY
Once the drying cycle is complete, display
shows a blinking "0", under anti-crease
and filter icon appear dash. If the BUZ-
ZER button has been pressed, an acoustic
signal sounds intermittently for about one
minute.
, to cooling