Page 1
Replace the Stand: Thread the free end of the micro USB cable from the side of the BB424 stand through the side of Rotate the stand 180 degrees. Seat the stand firmly in the hooks. the IP485g phone stand. Plug the USB jack into the USB port on the rear of the IP485g phone.
Page 2
Thread the free end of the USB cable from the side of the second BB424’s stand through the Connecting a Fourth BB424 (Optional) side of the first BB424’s stand. Plug the USB jack into the Out 2 USB port on the first BB424. (No Additional Power Source Required) After a few seconds, the second BB424 powers on and runs through a series of system tests.