Quick Reference; Attaching/Detaching The Stand; Setting The Tv On The Wall; Hanging On The Wall - Sharp LC-32SB24U Operation Manual

QUICK REFERENCE
Before attaching (or detaching) the stand, unplug the AC Y4_l'_f/f_%
cord from the AC iNPUT terminal.
Before perfo/ming work spread cushioning over the base
area to lay the TV on This will prevent it from being
damaged.
• Attach the stand in the correct direction.
Do not remove the stand from the 1_/unless using an
optional wall mount bracket to mount it.
• Be sure to follow the instructions. Incorrect installation
of the stand may result in tbe TV falling over.
1 Confirm that there are 9 screws and a hex key
supplied with the stand unit.
2 Attach the supporting post for the stand unit onto
the base using the box for the stand unit as shown
below.
Hox k oy_ @ C'r_ =
3 r_ Insert the stand into the openings on the bottom
of the TV.
"2', Insert and tighten the 4 screws into the 4 holes
on the rear of the TV.
_'f_ _ _'_s .......
Soft c
* To detach the stand, perform the steps in reverse order
• This TV sbould be mounted on tbe wall only with the
AN-gTAG5 (SHARP) wall mount bracket. The use of
other wall mount brackets may result in an unstable
installation and may cause serious injuries.
= Installing the TV requires special skill that should
only be performed by qualified service personnel.
Customers should not attempt to do the work
themselves. SHARP bears no responsibility for
improper mounting or mounting that results in
accident or injury.
Using an optional bracket to mount the "rv
• You can ask a qualified service professional about
using an optional AN 37AG6 bracket to mount the TV
to the wall.
• Carefully read the instructions that come with the
bracket before beginning work.
f
Hanging on the wall
AN 37AG5 wall mount bracket.
(See the bracket instructions for details.)
Vertica] mounting Angular mounting
About setting the 13/angle
0/5/10/15/20 <
LC-32SB24U
The center of the display:
_/,_ il/ch (4.0 mm} ul/der
the "A" position.
LC-37SB24U
The center of the display:
1/4 inch (6.0 ram) above
the "A" position.
Refer to the operation
manual d AN 37AG5 for
details.
Detach the cable clamp on the rear of the %/when using
the optional mount bracket.
Due to the terminal configuration on this %/, when you
walPmount this model, make sure there is enough space
between the wall and the %/for the cables,
To use this %/mounted on a wall, first remove the
adhesive tape at the 4 locations on the rear of the %/, and
then use the screws supplied with the wall mount bracket
to secure the bracket to the rear of the %/