Document Feeding System; Process Tray Assembly - Canon Finisher-T1 Service Manual

3.3
Document Feeding
System

3.3.1 Process Tray Assembly

3.3.1.1 Removing the
Front Door
Refer to Procedure 3.1.5
3.3.1.2 Removing the
Rear Upper Cover
Refer to Procedure 3.1.1
3.3.1.3 Removing the
Escape Tray Cover
Refer to Procedure 3.1.6
3.3.1.4 Removing the
Front Inside Upper
Cover
Refer to Procedure 3.1.4
3.3.1.5 Removing the
Grate-shaped
Guide
Refer to Procedure 3.1.2
3.3.1.6 Removing the
Tray 1
Refer to Procedure 3.3.2
0009-4502
0009-4504
0009-4419
0009-4505
Upper
0009-3651
0009-3652
3.3.1.7 Removing the
Tray 2
Refer to Procedure 3.3.3
3.3.1.8 Removing the
Grate-shaped
Guide
Refer to Procedure 3.1.3
3.3.1.9
Removing the
Processing Tray
1) Unfasten four snap fasteners [1] and
remove the sensor flag [3] from the stack
delivery roller [2].
Hold the snap fastener at the base when
unfastening because the sensor flag arm
can break easily. When fastening, insert
the boss of the sensor flag snap fastener
in the hole on the processing tray side.
Chapter 3
0009-3653
Lower
0009-4506
0009-3636
3-9