Advertisement
mode
mode
To configure the mode of an E1 line that has been mapped to a TUG-3, use the mode controller
configuration tug3 command.
To configure the mode of an E1 line that has been mapped to a AU-3, use the mode controller
configuration au3 command.
Use the no form of this command to disable the mode configuration.
Syntax Description
c-12
Defaults
c-12
Command Modes
Configuration controller tug3 (for an E1 line mapped to a TUG-3)
Configuration controller au3 (for an E1 line mapped to an AU-3)
Command History
Release
12.0(14)S
Usage Guidelines
You can configure each of the TUG-3s or AU-3s of a PA-MC-STM-1 to carry a set of TU-12s (E1s
mapped into TU-12s). The mode c-12 command configures the mode of operation of a TUG-3 or AU-3
and specifies that the TUG-3 or AU-3 is divided into 21 TU-12s, each carrying an E1.
Examples
The following example configures the AUG-mapping of the SONET controller to AU-3 and specifies the
mode of AU-3 1 to c-12:
Router(config)# controller sonet 1/0/0
Router(config-controller)# aug mapping au-3
Router(config-controller)# au3 1
Router(config-ctrlr-au3)# mode c-12
The following example configures the AUG-mapping of the SONET controller to AU-4 and specifies the
mode of TUG-3 1 of AU-4 1 to c-12:
Router(config)# controller sonet 1/0/0
Router(config-controller)# aug mapping au-4
Router(config-controller)# au-4 1 tug-3 1
Router(config-ctrlr-tug3)# mode c-12
12.0(14)S
30
mode {c-12}
[no] mode {c-12}
The TUG-3 or AU-3 is divided into 21 TU-12s, each carrying an E1.
Modification
This command was introduced.
Multichannel STM-1 Port Adapter for the Cisco 7500 Series Router
Advertisement
