AEG LAVATHERM 65170AVM User Manual page 18

18 www.aeg.com
15.3 Load door reversal
WARNING!
Before changing the door
stop, disconnect the mains
plug.
Note regarding contact
protection: The appliance is
only secure for operations
again once all plastic parts
have been put.
1. Open load door.
2. Unscrew hinge A from the front of
the appliance and remove the load
door.
3. Remove cover plates B. To do this,
put a thin screwdriver into the slots
as shown in the illustration, push
down lightly and remove the cover
plates.
A
A
4. Use an applicable tool and apply
pressure to unlock part C, remove
and turn it through 180°, then put on
the other side. There is a small spring
below locking block C. To put all
parts together correctly, look at the
illustrations:
B
C
5. Unscrew hinge A from the load door
B
and turn it through 180°, then put on
the opposite side and screw down.
6. Turn cover plates B through 180° and
put them on the opposite side.
7. Unscrew cover plates D from the
front of the appliance, turn through
180° and screw down on the
opposite side.
E
8. Unscrew door lock E, push down
lightly and remove from the front of
the appliance.
F
D
E
D
F