Connecting Power Supply - Bosch AMC2 Installation Manual

20 en | Installing
4.7

Connecting Power Supply

Connect the power supply to the POWER 7-pin pluggable screw connector. Refer to
Connecting Diagrams, page 44 for a complete diagram of the power supply connector.
Figure 4.8: Location of the power supply connector
Connect an external power supply (10 - 14 Vdc) for the AMC2 device at pin 1 (positive) and
pin 3 (0 V) of the pluggable screw connector.
If an uninterruptible power supply (UPS) is used, the relay output for power good signals from
the UPS is connected to the following pins:
–
–
–
Otherwise these pins must be short-circuited.
2018-02 | AMC2-4R4 |
pin 4 and 7 for power good AC
pin 5 and 7 for power good Battery
pin 6 and 7 for power good DC
Installation Manual
AMC2 Modular Controller
Bosch Access Systems GmbH