WIRELESS CENTER PART NAMES
TV main unit
Transmission
Front
POWER
SIGNAL LEVEL
MAIN
POWER
MAIN
POWER indicator
POWER
· Green:
Operation in
button
progress
(when power is on)
· Red: Standby
Note:
• The distance for which transmission is possible between the
main unit and Wireless Center is about 15 metres. However,
this distance may vary depending on the location or
conditions under which the Wireless Center is used.
• If the main unit gets close to the Wireless Center, there may
be cases where noise appears on the screen. In this case,
keep the main unit away from the Wireless Center until the
noise decreases, or try to change the transmission channel
setting (page 28).
Setting up the Wireless Center
• The Wireless Center can be placed horizontally or upright.
• When placing horizontally:
The side on which the rubber feet are attached is the
bottom.
Rubber foot
Wireless Center
Antenna
input
terminal
SIGNAL LEVEL
indicator
(Reception gain)
· Green:
Communication
Antenna
in progress
output
· Red:
terminal
Difficulty
in transmission
· Not lit:
Not communicating
Rubber foot
POWER Indicator
When the TV is turned off with the remote control, the
Wireless Center is switched to standby (POWER indicator
is lit red). (There may be a time lag of about 5 to 6
seconds.)
Placing the Wireless Center Where You Want It
We recommend placing the Wireless Center in an area
where there are no obstructions to impede radio wave
transmission/reception.
(Do not place the Wireless Center in a box.)
Rear
VIDEO
AUDIO (L)
AV-IN1
AUDIO (R)
IN
AV-IN2
MONITOR
AV-IN3
AV-IN1
AV-IN1
/OUT
OUT
VIDEO
ANT.
AUDIO
L
AUDIO
OUT
R
MONITOR
OUT
S-VIDEO
MONITOR OUT
(S-VIDEO)
MONITOR
OUT
VIDEO
AV-IN2
AUDIO (L)
/OUT
AUDIO (R)
VIDEO
AUDIO (L)
AV-IN3
AUDIO (R)
• When placing upright:
Fasten the stand to the bottom of the Wireless Center with
the screws provided.
Wireless Center
stand
* Failure to securely fasten the stand may cause the
Wireless Center to tip over during use.
AV-IN1 (S-VIDEO)
IR
POWER
FACTORY
OUT
INPUT
SERVICE
DC12V
Factory
adjustment
terminal
VIDEO
AUDIO (L)
POWER INPUT
AUDIO (R)
DC 12V
Video control
terminal
17