LG G Pad X2 Start Manual page 38

TIA Safety Information
The following is the complete TIA Safety Information for
wireless handheld devices.
Exposure to Radio Frequency Signal
Your wireless handheld portable device is a low power radio
transmitter and receiver. When ON, it receives and sends out
Radio Frequency (RF) signals.
In August, 1996, the Federal Communications Commissions
(FCC) adopted RF exposure guidelines with safety levels for
handheld wireless devices. Those guidelines are consistent
with the safety standards previously set by both U.S. and
international standards bodies:
ANSI C95.1 (1992) *
NCRP Report 86 (1986)
ICNIRP (1996)
* American National Standards Institute; National Council on
Radiation Protection and Measurements; International
Commission on Non-Ionizing Radiation Protection
Those standards were based on comprehensive and periodic
evaluations of the relevant scientific literature. For example,
over 120 scientists, engineers, and physicians from
universities, government health agencies, and industry
reviewed the available body of research to develop the ANSI
Standard (C95.1).
The design of your device complies with the FCC guidelines
(and those standards).
Tips on Efficient Operation
For your device to operate most efficiently:
Don't touch the antenna unnecessarily when the tablet is in
use. Contact with the antenna affects call quality and may
cause the tablet to operate at a higher power level than
otherwise needed.
Electronic Devices
Most modern electronic equipment is shielded from RF
signals. However, certain electronic equipment may not be
shielded against the RF signals from your wireless device.
Pacemakers
The Health Industry Manufacturers Association recommends
that a minimum separation of six (6) inches be maintained
between a handheld wireless device and a pacemaker to avoid
36