Bungard Compacta L30 Instructions For Use Manual

Compacta L30
Instructions for use
Bungard Elektronik ·GmbH&Co KG· Rilke Str. 1 · D-51570 Windeck
Tel 02292 5036 · Fax 6175 · info@bungard.de
Plating line
Contents
Safety instructions
Equipment
Cleaning
Spare parts
Technical data
First test
Chemicals Set-Up
Through Hole Plating process
sequence
Replenishment/Bath maintenance
Appendices:
Electrical circuit
Chemistry Set-Up
Process Flow Table
Plating System Steps descriptions
Safety instructions
1. General
Do not use the appliance for any other
application than through hole plating
of PCB material. Read all safety in-
structions and all operating instruc-
tions thoroughly before using the unit
for the first time.
Keep these safety instructions and ope-
rating instructions somewhere safe in
case you need to refer to them again in
the future.
2. Safety warnings
In your own interest pay attention to
all safety warnings on the unit and in
the operating instructions. Follow the
instructions on operation and use of
1
the unit in every respect.
2
3. Ventilation
3
Wherever you put the unit, always en-
sure there is sufficient ventilation. An
3
exhaust system may be necessary de-
3
pending on your local requirements.
4
4. Heat and moisture
4
To prevent fire or the risk of electric
shock, keep this unit out of the rain and
6
away from moisture. Do not place the
7
unit close to sources of heat like radia-
tors or hot air shafts.
5. Electric power
To avoid the risk of electric shock, do
not remove the housing and do not
open the back. There are no user ser-
viceable parts inside.
Page 1