Troubleshooting; Troubleshooting Table - Fujitsu LifeBook E Series User Manual

Wireless LAN.book Page 19 Wednesday, November 28, 2001 11:30 AM

Troubleshooting

This chapter contains troubleshooting information, including causes and actions, for problems you may find while
using this device.

TROUBLESHOOTING TABLE

Problem
An exclamation
mark (!) or cross
(x) is attached to
[Intersil PRISM
Wireless LAN PCI
Card].
Other computers
are not displayed
when the
[Network
Computer] icon is
double-clicked.
Possible Cause
A failure to Restart the computer.
recognize the
device.
A failure in Restart the computer.
installing the
driver.
You did not enter Make sure that you enter user name and password and click
the password [OK] when starting Windows 98. If you forget your pass-
when Windows 98 word, enter another user name. A new user name and pass-
started. You clicked word is registered in the computer.
[Cancel] or [ESC]
when User Name/
Password window
was shown.
The network has Check the setting for the protocol, workgroup, and sharing.
not been set up
To check this, you need a different procedure, depending
correctly.
upon the operating system that you use. Refer to the appro-
priate section of this manual.
It takes time before Perform the following steps to search for the computer.
the network is
Click [Start] -> [Search] -> [Other Computers].
searched and the
Enter the computer name that you are connecting to in
computer
[Name], and click [Search].
connected is
Double-click the icon of the computer that has been
displayed.
searched.
A failure in Make sure that the driver is correctly installed.
installing the
driver.
The TCP/IP Make sure that the TCP/IP protocol is installed. To check this,
protocol is not you need a different procedure, depending on the operating
installed, or, the IP system that you use. Refer to the appropriate section of this
address is not set manual.
correctly.
T r o u b l e s h o o t i n g
Possible Solution
19