Radio Thermostat CT80 Install Manual page 7

Mount the CT80 to Wall
1. Hold the CT80 against the wall, with the wires coming over the
top; above terminal block. The CT80 will cover the hole in the wall.
2. Position CT80 for best appearance.
3. Attach the CT80 to the wall with the screws provided.
4. If you are mounting the CT80 to sheet rock or if you are using the
old mounting holes, use the plastic anchors provided.
5. Mark first and drill a 3/16-in.(4.8mm) hole for the insert at each
from
HEAT/COOL
system
Screw to wall
screw location, then mount the unit.
Place wires like this
inside wire groove
Wall
CT80
Wires
Wall
anchor
7
PG