Before Operating; Manual Operation - Sharp Carousel R-90GC Operation Manual

B E F O R E O P E R A T I N G
• Before operating your new oven make sure you read
and understand this operation manual completely.
• Before the oven can be used, follow these
procedures:
1. Plug in the oven. Close the door. The oven display
will show PRESS CLEAR AND CLOCK.
2. Touch the STOP/CLEAR pad.
will appear.
:
3. Set clock (See below).
4. Heat your oven without food by using Refresh
mode. (See page 28).
TO SET THE CLOCK
• Suppose you want to enter the correct time of day
12:30 (A.M. or P.M.).
Touch CLOCK pad and
1
number pad 2 .
Enter the correct time
2
of day by touching the
numbers in sequence.
3
Touch CLOCK pad
again.
This is a 12 hour clock. If you attempt to enter an
incorrect clock time, ERROR will appear in the display.
Touch the STOP/CLEAR pad and re-set the clock.
• If the electrical power supply to your oven should be
interrupted, the display will intermittently show
PRESS CLEAR AND CLOCK after the power is re-
instated. If this occurs during cooking, the program
will be erased. The time of day will also be erased.
Simply touch STOP/CLEAR pad and reset the clock
for the correct time of day.
SHARP SIMPLY THE BEST
STOP/CLEAR
Touch the STOP/CLEAR pad to:
1. Erase if you make a mistake during programming.
2. Cancel timer.
3. Stop the oven temporarily during cooking.
4. Return the time of day to the display.
5. Cancel a program during cooking, touch twice.
SHARP SIMPLY THE BEST
P R O C E D U R E
M A N U A L O P E R A T I O N
MICROWAVE TIME COOKING
Your oven can be programmed for 99 minutes 99 sec-
onds (99.99). Always enter the seconds after the min-
utes, even if they are both zeros.
• Suppose you want to cook for 5 minutes at 100%.
Enter cooking time.
1
2
Touch START pad.
TO SET POWER LEVEL
There are eleven preset power levels.
Using lower power levels increases the cooking time
which is recommended for foods such as cheese, milk
and long slow cooking of meats. Consult cookbook or
recipes for specific recommendations.
TOUCH POWER
LEVEL PAD
once
twice
3 times
4 times
5 times
6 times
7 times
8 times
9 times
10 times
11 times
• Suppose you want to defrost for 5 minutes at 30%.
Enter cooking time.
1
2
Touch POWER LEVEL
pad 8 times or hold down
until the desired power
level appears.
3
Touch START pad.
When the defrost time is complete, a long tone
4
will sound and END will appear in the display.
You can program up to 4 automatic cooking sequences.
Follow directions on page 26. Note that POWER
LEVEL must be entered first when programming mul-
tiple sequences.
9
P R O C E D U R E
APPROXIMATE COMMON WORDS
PERCENTAGE FOR
OF POWER POWER LEVELS
100% High
90%
80%
70% Medium High
60%
50% Medium
40%
30% Med Low / Defrost
20%
10% Low
0%
P R O C E D U R E
x 8