York Elite 1600 ARC Operating Instructions

Winchester .224 dia. 22-250 Rem, 55gr. Ballistic Silvertip at 3680fps
Winchester .224 dia. 22-250 Rem, 55gr. PSP at 3680fps
Federal Cartridge .227 dia. 270 Win, 150gr. Ballistic Tip at 3060fps
Federal Cartridge .227 dia. 270 Win, 150gr. Partition at 3000fps
Remington Arms .227 dia. 270 Win, 140gr. PSPCL Ultra at 2925fps
Remington Arms .227 dia. 270 Win, 150gr. SPCL at 2850fps
Winchester .227 dia. 270 Win, 150gr. Partition Gold at 2930fps
Winchester .227 dia. 270 Win, 150gr. PP-Plus at 2950fps
Federal Cartridge .308 dia. 30-06 Sprg, 180gr. AccuBond at 2700fps
Federal Cartridge .308 dia. 30-06 Sprg, 180gr. Bear Claw at 2700fps
Remington Arms .308 dia. 30-06 Sprg, 180gr. A-Frame at 2700fps
Remington Arms .308 dia. 30-06 Sprg, 180gr. BRPT at 2700fps
Winchester .308 dia. 30-06 Sprg, 180gr. FailSafe at 2700fps
Winchester .308 dia. 30-06 Sprg, 180gr. Partition Gold at 2750fps
Federal Cartridge .308 dia. 300 WSM, 180gr. AccuBond at 2960fps
Federal Cartridge .308 dia. 300 WSM, 180gr. Bear Claw at 3025fps
Winchester .308 dia. 300 WSM, 180gr. Ballistic Silvertip at 3010fps
Winchester .308 dia. 300 WSM, 180gr. FailSafe at 2970fps
Remington Arms .308 dia. 300 R.S.A.U.M., 180gr. PSPCL Ultra at 2960fps
Remington Arms .308 dia. 300 Wby Mag, 180gr. PSPCL at 3120fps
Above are a few of the most popular calibre/load combinations. A complete list of
approximately 2000 calibre and load combinations can be found on Bushnell's website
(www.bushnell.com).
After you have determined which ballistic group corresponds to your calibre and load,
select this ballistic group (see MENU SETUP above). The internal formula will determine
amount of bullet-drop/holdover in inches or centimetres based upon distance, angle
and ballistics of your calibre and load.
This state-of-the-art digital technology allows the hunter or shooter to know precisely
where to hold for an effective shot. This information should be treated as a helpful guide
or tool and in no way should it ever replace practice and familiarity with your rifle,
cartridge and load. We encourage practice shooting at different ranges so you know
how your rifle, cartridge and load will perform under various conditions. Always know
what is behind your bullet; if you don't know, don't take the shot.
EXAMPLE
You have a 300 WSM and are shooting the following Winchester brand load: 180gr.
Ballistic Silver Tip bullet at 3010 FPS muzzle velocity. This combination falls under
Ballistic Group "F". After setting the rangefinder to ballistic group "F", go to the range
and sight in your riflescope at 100yds. If you then take a shot at a target at 317yds, the
bullet-drop will be 9ins. If the shot is at an angle of 27° upward, then the corrected
bullet-drop will be 8ins.
WHAT IF YOUR CALIBRE IS NOT LISTED?
While we have taken great care to include as many calibres and brand names in our
ballistics tables, new loads are always being developed. In addition, some shooters load
their own ammunition with unique ballistic characteristics. If you cannot find your load
in our ballistic tables, you can still use the bullet-drop feature of the laser rangefinder.
As above, sight in your rifle at 100yds. Then shoot the rifle, without adjusting the
riflescope, at 300yds. Measure the bullet-drop from point of aim. Using this drop, select
the ballistic group from below. If you will be shooting longer distances then you may
want to check the bullet-drop at 500yds. Because there is enormous variation in rifle
barrels, chambers and hand loads, you should thoroughly test the ballistic setting before
actual hunting. You may need to move up or down one group depending upon your
tests.
If Bullet-drop is @300yds @300m @500yds @500m
Use:
A 25-31in 63-79cm 114-146in 291-370cm
B 20-25in 50-63cm 88-114in 225-291cm
C 16-20in 40-50cm 72-88in 182-225cm
D 13-16in 34-40cm 61-72in 155-182cm
E 12-13in 30-34cm 55-61in 139-155cm
F 10-12in 25-30cm 47-55in 119-139cm
G 8-10in 20-25cm 39-47in 99-119cm
H < 8in < 20cm < 39in < 99cm
RAINGUARD HD
The outer surfaces of the objective and eyepiece lenses are coated with RainGuard
HD. This is Bushnell's permanent, patented, water repellant lens coating that prevents
fogging by causing condensation from rain, sleet, snow or even your own breath to bead
up into much smaller droplets than on standard coatings. Smaller uniform droplets
scatter less light which results in a clearer, brighter view.
York Survey Supply Centre, Prospect House, George Cayley Drive, Clifton Moor, York, England YO30 4XE
Tel: +44 (0) 1904 692723
E-Mail: sales@yorksurvey.co.uk
Ref:.. \operat98\instructions 18\431590.qxp 05-01-18
H CLEANING
G Gently blow away any dust or debris on the lenses (or use a soft lens brush). To remove
F dirt or fingerprints, clean with a soft cotton cloth, rubbing in a circular motion. Use of a
F coarse cloth or unnecessary rubbing may scratch the lens surface and eventually cause
E permanent damage. For a more thorough cleaning, photographic lens tissue and
D photographic-type lens cleaning fluid or isopropyl alcohol may be used. Always apply
E the fluid to the cleaning cloth - never directly on the lens.
E
D TRIPOD MOUNT
D Moulded into the bottom of your Elite 1600 ARC is a threaded tripod mount that will
D allow you to attach a tripod for a more stable operation during long periods of use.
D
D SPECIFICATIONS:
D Weight: 10oz
F Ranging accuracy: ±1yd
F Range: 5 - 1600yds / 5 - 1463m
F Magnification: 7x
F Objective diameter: 26mm
E Optical coatings: Fully multi-coated
F RainGuard HD coating
Display: VDT
Power source: 3V Lithium (included)
Field of view: 340ft @ 100yds / 104m @ 1000m
Extra long eye relief: 19mm
Exit pupil: 3.7mm
Waterproof
Built-in tripod mount
Includes battery, carry case and strap
TROUBLESHOOTING TABLE
If the unit does not turn on - Display does not illuminate:
• Depress the POWER button.
• Check and, if necessary, replace battery.
If the unit powers down (display goes blank when attempting to power the laser):
• The battery is either weak or low quality. Replace the battery with a good quality 3V
Lithium battery (CR123).
If target range cannot be obtained:
• Make sure Display is illuminated
• Make sure that the power button is depressed
• Make sure that nothing, such as your hand or finger, is blocking the objective lenses
(lenses closest to the target) that emit and receive the laser pulses
• Make sure unit is held steady while depressing power button
NOTE: The last range reading does not need to be cleared before ranging another
target. Simply aim at the new target using the LCD's reticle, depress the power button
and hold until new range reading is displayed.
FCC NOTE
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Shielded interface cable must be used with the equipment in order to comply with the
limits for a digital device pursuant to Subpart B of Part 15 of the FCC Rules.
Specifications, instructions and the operation of these products are subject to change
without any notice or obligation on the part of the manufacturer.
FDA Eye Safety
Class 1 laser product in accordance with IEC 60825-1:2007.
Complies with 21 CFR 1040.10 and 1040.11 for laser products except for deviations
pursuant to Laser Notice No. 50, dated June 24, 2007.
Caution: There are no user controls, adjustments or procedures. Performance of
procedures other than those specified herein may result in access to invisible laser light.
Fax: +44 (0) 1904 690385
www.yorksurvey.co.uk
Elite 1600 ARC
Laser Rangefinder
Code: 431590
Operating
Instructions
©York Survey Supply Centre 2018