Introduction - Cub Cadet 353 Operator's Manual

This section will help you to become familiar with the components of the 45 " Snow Thrower Attachment, Model 353.
Select a firm level surface that is large enough to accommodate both the snow thrower assembly and the tractor w/
front hitch asssembly. After removing the upper crating material, remove the hardware pack and carefully roll the
snow thrower assembly rearward so that it rests on its bottom. When repositioning the snow thrower, use care not
to pinch or bind the chute crank support tube (D, Figure 1). Cut the tie strap(s) and remove any packaging material
from the chute crank rod/tilt handle/support tube assembly (C thru E, Figure 1), then position to the left side of the
snowthrower assembly. Refer to Figures 1 and 2 to confirm that all parts are present and to aquaint yourself with
the part descriptions. Throughout the instructions in this manual the parts shown in Figures 1 and 2 will be identified
by name, followed by either their callout letter or number in parenthesis.
C
SECTION I. INTRODUCTION
E
D
B
F
REF.
NO.
A Snow Thrower Assembly
B Discharge Chute Assembly
C Chute Tilt Handle Assemby
D Chute Crank Support Tube Assembly
E Chute Crank Rod Assembly
F Chute Crank/Mtg. Bracket Assembly
A
Figure 1
6
DESCRIPTION QTY.
1
1
1
1
1
1