Page 1
V-Plex® Series Motion Sensors DT8050A-SN ® ® V-Plex DUAL TEC Motion Sensor with Anti-Mask - Installation Instructions Mounting location guidelines: • The optimal range is obtained at a mounting height of 7’ 6” (2.3m). • Allow a clear line-of-sight to all areas to protect. •...
Page 2
MOUNT THE SENSOR (3.5 mm) #6 x 1 1/4" (3.5 mm x 32 mm) • [A] = Wall mounting holes. • [B] = Corner mounting holes. • The rear tamper plate MUST be mounted to a stud, solid wood, or with a robust wall anchor.
Page 3
WALK TEST THE SENSOR AND ADJUST AS NEEDED Walk Test Reset 30 sec SENSITIVITY < 4’ (1.2m) 1/2 sec. hold 4x Power Walk Test Normal Trouble Anti-Mask Slow Fast DT8050A-SN_step6-ii Blink Alarm Alarm Blink Fast Yellow Microwave Microwave Blink 1. Apply power to the sensor. Initialization is complete when the LED Green ON PIR ON PIR...
Page 4
PROGRAM THE SENSOR TROUBLESHOOTING This sensor is a serial number device. Refer to the control TROUBLE* panel’s manual for instructions on registering devices and NORMAL Mask Self-Test Failure programming. Red LED Flashing ® For all V-Plex panels, program the sensor Zone Type as INT Yellow LED Flashing FOLLOWER 04 and the INPUT TYPE as “06”...
Page 5
APPROVAL LISTINGS • FCC part 15, Class B verified • IC ICES-003, Class B verified • UL 639 • ULC S306-03 • SIA-PIR-01 Passive Infrared detector standard features for false alarm immunity. Product must be tested at least once each year. All wiring must be in accordance with: the National Electrical Code (ANSI/NFPA70);...