Kenmore 625.34854 Owner's Manual page 5

SECTION 1
WATER SOFTENER START-UP
I I
lB. CHECK LIST OF ALL STEP-BY-STEP GUIDES TO INSTALL
Refer to the Installation Manual, part no.
7141417, for step-by-step guides.
To be sure you have done all the steps to install
the softener, read the following list. Page num-
bers referred to are in the Installation Manual.
4' Is the house water flow going INTO the soft-
ener valve INLET? Trace piping to be sure.
See pages 10 and 11.
_/ Is the plumbing bypass valve (or 3 valves) set
for SERVICE? See FIG. 12, page 19 of this
manual.
INLET
4
4
4
Is the valve drain hose connected the right
way, and without sharp bends or kinks that
could stop or reduce water flow? See page 16.
Is the softener power cable connected to the
transformer? Is the transformer plugged into
an inside, 120V-60Hz electrical outlet? See
page 20.
Be sure to restart the water heater. See page
20.
J
plastic