Table of Contents
Advertisement
Before Calling for Service, Check the Following Points
If Laundry
Center
does not start::
• Is plug disconnected
from power
supply or is plug loose in outlet, not
making good connection?
• Is house fuse blown orcircuit breaker
off?.
• Is washer Timer knob pulled out?
• Is lid closed if in spin cycle?
• Is dryer door closed?
• Is Timer set?
• Have you pressed Start button for
about two seconds?
• The internal motor protector will stop
motor if it is ow_rheated, but will
automatically reset after motor cools.
Press Start button for two seconds to
restart dryer.
If water does not enter:
• Are faucets tumext on?
• Are filter screens clogged? They are
located at water wtlve ends of hoses.
• Are hot and cold hoses reversed?
Hot water hose is identified.
• Is the Wash Ternperature
selector
pointing
directly
to Hot, Cold or
Warm? The washer will not fill with
water if the selector
is pointing
between 2 setting,;.
If water does not drain:
• Are there kinks in drain hose?
• Is drain system clogged or restricted?
• Is drain hose
lower that 33" in
standpipe? This can cause siphoning
and washer will continue to fill. See
Installation Instructions
for further
information.
• Is the lid closed? The washer will not
spin out wash water unless the lid is
closed.
If water is leaking
at hose
connection:
• Disconnect hose from valve. Remove
rubber washer at end of hose and
replace, with new washer. Reconnect
hose to valve. DO NOT overtighten.
I_kWARNINGI Disconnect
electrical
supply cord before servicing laundry
center. Failure to disconnect can cause
electrica]t shock or serious personal
injury.
If articles are spotted
or not clean:
• Is there,iron in the water? Iron remover
or water softener may be needed.
• Is fabric softener dispenser cracked?
Fabric softener applied directly to
article.s will cause
stains
which
resemble oil or grease stains.
• Is washer overloaded? Check loading
section of..this book.
If articles
are still wet
at end of spin cycle:-
•
Is load unbala:aced? Unit is designed
to complete cycle with unbalanced
load which conld leave articles damp.
Redistribute
articles and repeat spin
cycle.
• Is drain system clogged or restricted?
If articles
are not
drying satisfactorily:
• Is lint filter clean?
• Are exhaust duct and vent hood free
of obstruction or lint blockage?
• Is dryer set at,!_ir Fluff for 20 minutes
which provides no heat? -
• Are there too :nany articles in dryer?
Check loadin_; section of this booklet.
• Have installation instructions
been
followed?
I_WARNING]
Do not use plastic
flexible duct to _xhaust dryer. Replace
plastic duct with rigid or flexible metal
duct. Excessive lint can build up inside
duct work, creating a fire hazard and
restricting air flow. Restricted air flow
will increase dl_.¢ingtime.
If you still have a problem after checking these items, you
can obtain service simply by contacting your nearest Sears
Service Center throughout the United States. When calling
your Sears Service Center, be ready to give the model
number, serial number, and date of purchase of your
appliance.
Optional Accessories
for your Kenmore Laundry Center
available fr rn your nearest Sears Service Center.
•
Fabric Softener Dispenser P/N 145836-000
•
Drying Rack PIN 131155200
•
Syphon Break P/N 0766660-000
•
Drain Hose, 9 Ft. Long P/N 142337-000
•
For additional accessories check Laundry Center Parts List or your local Sears Service Center.
P/N 131217900
6/93
Advertisement
Table of Contents
