Sears 134411800 Installation Instructions

Meter Case Installation Hardware
Contents: Tools Required:
3/8 x 16 lock nut (1) 9/16 socket and drive
/ >
Installation Instructions:
1. Remove meter case access door.
2. InstaII 3/8 lock nut onto security bolt and tighten securely.
3. InstaII meter case access door.
INSTRUCTIONS TO CHANGE THE NUMBER OF COIN SLIDE INSERTIONS TO START APPLIANCE,
1. Disconr_ect power from machine,
2. ]urn Shaft & Cam Assembly in a clockwise direction until switch lever arm drops into cam notch
(Fig. 2),
3. Lift Adjusting -Iab away from cam with finger and turn -tab to desired number. Make sure Tab\
locks into place in new position,
4. ]urn Shaft & Cam Assembly in a clockwise direction until switch lever arm is on top of ]ab to
assure that both mechanism switches are open (Fig, 3)
5. Reconnect power to machine,
-,-- C AM NOTCH
x
x
AD0UST: NT
\ _ TAB
\ \
FIGURE 2
LIFT
I CLOCKWISE
DIRECTION
-- OSE FINGER TO
TAB
FIGURE 3
P/N 134411800 (0403)