Download Print this page

Dimplex Free-E Installation Manual

Heat water for free with solar pv
Hide thumbs Also See for Free-E:

Advertisement

Quick Links

Advertisement

loading

Summary of Contents for Dimplex Free-E

  • Page 10 Position Description PV Panels Inverter PV Solar Electricity Meter Distribution Box Free-E Domestic Hot Water Cylinder Free-E Meter and CT Clamp(s) Import / Export Electricity Meter Grid...
  • Page 14 Position Description Free-E Master Module Free-E Meter and CT Clamp (clip on) Screw Pack (6x Screws, 6x Wall Plugs) 3x Strain Relief Clamps, 6x Screws...
  • Page 16 Minimum Clearance 500mm top and bottom 188 mm 279 mm...
  • Page 17 Max . T ilt A ng le 45°...
  • Page 19 70mm...
  • Page 21 Full schematics for the wiring of the Free-E are included in the Appendices section of this manual GRID LOAD RS485 / MODBUS INPUT OUTPUT L3 L2 L1 N E E L3 L2 L1 S B A S B A Only used if Modbus (wired) comms needed...
  • Page 22 S B A L2 L3 Only used if Modbus (wired) comms needed...
  • Page 23 WARNING CAUTION Distribution Board Grid Input...
  • Page 24 AC1-AC2 External Input...
  • Page 25 The MAINS LED is green. The blinking patterns of the The STATUS LED has lights indicate the device three available colours: status (see table). MAINS STATUS Green Amber Pairing Button Status LED Blinking Pattern Details Mains detected OK Green LED ON Green LED ON for 3 seconds, Mains restarting flashes off for 0.5 seconds...
  • Page 28 Device Pairing Device Pairing Searching for Device Do you want to begin pairing ENT E R your devices? Please hold the pairing button on the Free-E meter Select OK ABORT for at least 3 seconds Press Enter Button Device Device Pairing...
  • Page 29 Select RF Channel RF Channel Selection Select RF Channel Channel 1 Successful Please Wait Channel 2 Channel 3 € Press NEXT to continue Channel 4 ABORT NEXT ABORT NEXT Single Heater / UFH Load Connection Supply Connected? Single Heater or UFH ENT E R Choose schematic type CANCEL...
  • Page 30: Commissioning Complete

    CT Direction Check Checking CT Direction Please Wait Please ensure that you CT is ENT E R connected in the correct configuration This may take up to Select N E XT 1 minute ABORT NEXT Press E NTER CT Direction Check CT Direction OK Failed Please reposition you CT...
  • Page 31 EXT . CTR L . ONLY 01/01/2015 00:00...
  • Page 33 +/- 1% kVAh Resolution 0.01 kVAh Certification Certification Metering Standard Class 1 (Accuracy only) Wireless Technology Radio Technology Dimplex GFSK Radio Frequency 868 MHz ISM Band Channels 4 Channels (1 - 4) Max Tx Power +13dBm Rx Sensitivity -105dBm@25Kbps Data Rate...
  • Page 34 Range of output power factor 0.9x … 1.0 Nominal Power factor 0.99 External Input voltage range 24 - 230Vac Peak Free-E efficiency 98.2% 1 PSU 5Vdc ……1A 1 Digital input/output General Purpose I/O Configurable inputs / outputs 1 Isolated input 24Vac..240Vac...