Advertisement
IMPORTANT: WE ADVISE YOU TO ..&.._FMBLE THE TEN T ONCE BEFORE GOING CAMPING TO BECOME FAMILIAR .WI'_I_13HE
ASSEMBLY OFTHETENT.
FOR THIS MODEL. IT IS RECOMMFNDED TWO PEOPLE_BE INVOLVED IN SETI'ING UP THISTENT.
NOTE: PLEASE
LOOK ATTHE
REPLACEMENT
PARTS DIAGRAMTO
SEE HOWYOUR
FRAME IS
ASSEMBLED.
• To prolong the lile of the tent floor, select a level, clean area for the campsite.
• To wevent damage to the zipper, unzip the doom and window flaps to allow air to enter the tent.
STEP 1:
STEP 2:
Spreadfly of tent out on the groundso the
undersideof the fly is facing up.
Locatethe twof_erg[assfly polese=ions. Each pole
sectionis shock corded together.Extendeach
section.Insertthe ends ofthe longerfiberglasspole
intothe pocketslocatedat the sides ofthe fly- Insert
the ends of the remainingfiberglasspole intothe
pocketslocatedat the front and rear of the fly.
STEP 6:
STEP 7:
Secure fly to frame by fastening the self-fastenem
on the fly around the metal frame,
With the help of another person, flip fly over so it is
updght. Attach the "J" hooks on the comers of the
fly into the open ends of the metal uprights. Adjust
tension as necessary.
STEP 3:
Each of the ridge poles of the tent consists of four
metal sections chain corded together. Carefully
extend each of the sections by joining them together
at the swages to form each section into the shape of
an arc. Slide each section through the sleeves on
the fly_
STEP 4:
STEP 5:
Using ties located in the center or fly, tie the
fiberglass and metal poles into place.
Lo_te the four metal pole sections. Each section
consists of three poles chain corded together.
Extend each section. While leaving fly on the ground,
join the bent end of the metal section to one end of
the metal ddge pole sections, which were inserted
into the fly sleeves. Repeat for the remaining three
pole uprights.
STEP 8:
STEP 9"
Lay tent out under the fly with the roof side up.
Unzip doom. Standing on the floor of the tent, hook
the center hook of the tent to the tent frame and
work your way out to the comers of the tent,
clipping tent hooks around the frame.
Insert the pins attached at each comer of the tent
into the open ends of each frame pole,
I
•
II I
II
............
Advertisement
