Standby Control; Network Standby; Power Button; Eco Solution - Samsung UH46N-E User Manual

Standby Control

You can set the screen standby mode to be applied when an input signal is received.
• Auto
Power-saving mode will activate if no input signals are detected even though a source
device is connected to the display.
The message No Signal will appear if no source device is connected.
• Off
The message No Signal will appear if no input signals are detected.
― If
No Signal is displayed although a source device is connected, check the cable
connection.
― If
No Signal Message is set to Off, the
If this is the case, set No Signal Message
• On
Power-saving mode will activate if no input signals are detected.

Network Standby

This feature keeps the network power on when the product turns off.
• Off / On

Power Button

The power button can be set to either turn on the power or turn on/off the power.
• Power On Only: Set the power button to turn on the power.
• Power On/Off: Set the power button to turn on/off the power.
No Signal message does not appear.
to On.

Eco Solution

MENU m → System → Eco Solution → ENTER E

Energy Saving

Reduce the power consumption by adjusting the screen brightness.
• Off / Low / Medium / High

Eco Sensor

To enhance your power savings, the picture settings will automatically adapt to the light in the
room.
• Off / On
― Adjusting the
Backlight setting under
― If the screen contrast is not sufficient, set the
may not comply with energy standards.
Min. Backlight
When Eco Sensor is On, you can manually adjust the minimum screen brightness.
Backlight is the darkest backlight mode. Make sure the
the Backlight setting.
― If
Eco Sensor is On, the display brightness may change (become slightly darker or brighter)
depending on the surrounding light intensity.
Picture while Eco Sensor is on will disable the Off.
Eco Sensor to Off. If the Eco Sensor
Min. Backlight setting is lower than
is Off, it
Min.
68