SERVICE AND ADJUSTMENTS
TO ADJUST
STEERING
WHEEL
ALIGNMENT
If steering wheel crossbars are not horizontal (left to right)
when wheels are positioned straight forward, remove steer-
ing wheel and reassemble per instructions in the Assembly
section of this manual.
FRONT
WHEEL
TOE-IN/CAMBER
The front wheel toe-in and camber are not adjustable on
your' unit If damage has occurred to affect the front wheel
toe-in or camber, contact your nearest authorized service
center
TO REMOVE
WHEEL
FOR
REPAIRS
(See
Fig. 27)
o
Block up axle securely,
°
Remove axle cover, retaining ring and washers to allow
wheel removal (rear wheel contains a square key - Do
not lose)
Repair tire and reassemble.
o
On rear wheels only: align grooves in rear wheel hub
and axle, Insert square key.
°
Replace washers and snap retaining ring securely in
axle groove.
o
Replace axle cover,
WASHERS
RETAINING
\
RING
AX
VER
'_LSQUARE
KEY
(REAR WHEELONLY)
FIG. 27
TO START ENGINE
WITH A WEAK BA'FrERY
(See Figs. 28)
_,_
CAU'fION:
Lead-acid batteries gener=
,_
ate explosivegases.
Keep sparks,flame
and smoking
materials
away from bat-
teries. Always.wear eye protection when
If your battery
is too weak to start the engine,
it should
be
recharged.
If "jumper
cables"
are used
for emergency
starting,
follow this procedure:
IMPORTANT:
YOUR UNIT IS EQUIPPED WITH A 12 VOLT
NEGATIVE
GROUNDED
SYSTEM
THE OTHER VEHICLE
MUST ALSO BE A 12 VOLT NEGATIVE GROUNDED SYSTEM.
DO NOT USE YOUR TRACTOR BATTERY TO START OTHER
VEHICLES
TO ATTACH JUMPER CABLES -
Connect each end of the RED cable to the POSITIVE (+)
terminal of each battery, taking care not to short against
chassis.
Connect one end of the BLACK cable to the NEGATIVE
(-) terminal of fully charged battery.
o
Connect the other end of the BLACK cable to a good
CHASSIS GROUND, away from fuel tank and battery
TO REMOVE CABLES, REVERSE ORDER -
o
BLACK cable first from left side of chassis and fully
charged battery.
RED cable last from both batteries.
"POSITIVE ....
NEGATIVE"
(+)
(-)
PANELO
FIG. 28
TO REPLACE
HEADLIGHT
BULB
°
Raise hood.
o
Pull bulb holder out of the hole in the backside of the gdll.
.
Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill
o
Close hood.
INTERLOCKS
AND
RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
°
Check wiring. 'See electrical wiring diagram in Repair
Parts section of this nranuaL
TO REPLACE
FUSE
Replace with 30 amp automotive=type plug-in fuse. The fuse
holder is located behind the dash.
TO REMOVE
HOOD
AND
GRILL
(See
Fig. 29)
o
Raise hood
°
Unsnap headlight wire connector.
°
Stand irr front of tractor_
Grasp hood at sides, tilt
forward and lift off of tractor.
•
To reinstall, slide hood pivot brackets into slots in
frame.
•
Reconnect headlight wire connector and close hood_
HO(
HEADLIGHT
WIRE
CONNECTOR
I
,t
22
FIG. 29