Tuner; Listening To The Tuner; Tuner Source Screens; Tuning Methods - Polaris 2879459 Manual

TUNER

LISTENING TO THE TUNER

To select one of the available tuner bands :
Press the Input source key ( ) to select input from each of the following in turn:
• AM
• FM
The applicable input source screen is displayed for each band.
Continuing to press the key will display the input source screens for Bluetooth and
Auxiliary as described in the section "Input Source Screens" on page 5.

TUNER SOURCE SCREENS

AM/FM
An example of a typical tuner input source screen is shown in Figure 2 below.
SOURCE NAME
S E E L C E T D
FREQUENCY
Figure 2 – Example source screen (AM input selected)
8

TUNING METHODS

You can use three methods to tune the overhead unit: automatic, manual and preset.
Rotary knob
To tune to a required frequency, channel or preset:
Press the Play / Pause key to step through the available tuning methods for each band:
Tuning Metho d
Tuning Method
Auto
Auto
Manual Manual
Preset
Preset
TUNING
MODE
Menu key Play / Pause Forward
When tuning with this method...
When tuning with this method...
• Press the Forward or Backward key to start searching for available
stations.
Note: The search stops when a station is found or when the unit has
scanned all available frequencies once.
• Press the Forward or Backward key to step through the range of
frequencies one at a time.
• Press the Forward or Backward key to step through available presets
(only available if there are two or more presets)
•
To tune to a speci c preset:
a. Press the Menu key.
b. Press the rotary Knob to select Presets.
c. Turn the rotary knob to highlight the desired preset.
d. Press the rotary knob to tune to the highlighted preset.
e. Menu exit. See "Menu Key Operation"
For further details, see "

Adding and Removing Presets".

Backward
9