Kenmore 2500 Owner's Manual page 7

[] 7
Unwind the rest of the tubing. Take care not to kink it.
Run the tubing along flat surfaces to the humidifier. Support the
tubing as needed to avoid contact with furnace.
II[l_lill
[] 8 Close previously opened faucet. Turn on main water
supply. Place a pall under the and of the tubing. Open the caddie
valve, Flush the line. Make sure there are no leaks along the line
or at the valve. Turn valve off.
[] 9
Removethe quickdisconnectsocket,brass compres-
sionnut,and brasssleevefromhardwarebag (Rg. 14). Withwater
supply tubingcutto the properlength,slide the brass compres-
sion nut and sleeve over the tubingas describedin Step 5, Page
6. Slipbrass insertintothe end of tubing.
F
-I Sleeve
L _Humiditier
QUICK DISCONNECT
ASSEMBLY
Nut
Sleeve
Insert
Quick Disconnect
Socket
1/4" Plastic
Water Supply
Tubing
[] 10
Insertthe tubingend intothe quick disconnectsocket
as far as it willgo and holditthere, threadthe brasscompression
nut onto the quick disconnect socket, then tighten using two
wrenches,one to holdquick disconnect s ocketand one to tighten
nut. DO NOT over tighten nut.
[] 11
Connectthe quickdisconnectsocketto theplug on the
valve body (Fig. 16).
To connect, pull back sleeve, push socket onto plug, release
sleeve.
To disconnect,pull back sleeve, unlockingquickdisconnectand
sealingwater supplyline,separate from plug.
[] 12
Turnonwatersupplyatsaddlavalva.Chackwaterlevel.
Water should be 3/8" below top of overflow compartmentwall
(Fig.17). If adjustment is necessary,disconnect w atersupplytub-
ing, and removefloat assembly(Fig. 18). See instructions on bot-
tom of float.To raise water level, turn float clockwise. T o lower
water level,turnfloat counterclockwise.
Float
Valve Button
Valve
Body
Float Pin
LI1 [t]! i1,1
Disconnect
Plug
[] 13
Attach front panel. Be sure lip at bottom of front panel
is inside lip at front edge of humidifier case.