Ranger Fisherman Series Owner's Manual page 49

Hide thumbs Also See for Fisherman Series:
Table of Contents

Advertisement

Electrical System
the boat. Pressing this key 1 time will activate the lights; pressing the key
a second time will turn off the lights. If the lights are left on, they will
automatically turn off after five minutes.
Dimming the Instrument Lights and Key Pad Lights
If the boat is equipped with the standard gauges, it is possible to dim
the gauge lights and keypad lights for night driving. First turn the keyless
ignition to the run position and press the interior light button leaving the
button depressed. You will see the gauge lights and keypad lights
oscillate from dim to bright. When the desired brightness is obtained,
release the interior light button.
Accessories
There are five accessory functions labeled "A, ACC, A1, A2, and A3".
The "A" accessory will drive the oxygenator option. All other accessories
buttons will drive any device up to 5 amps. Pressing the button once will
turn the accessory on; pressing a second time will turn the accessory off.
Horn
The button with the image of a trumpet is the horn button. Pressing
and holding this button will sound the horn; releasing this button will turn
the horn off.
Trim
On the bow keypad, the switch with the up arrow controls the trim up
and the switch with the down arrow controls the trim down. Pressing and
holding the button will allow the trim to function. Releasing the button will
cause the trim to stop.
Back Lighting
The back lighting will illuminate the keypad. After waking up the
system, it will turn on for 60 seconds or while in the wake mode, it will turn
on after any key press for 60 seconds.
Resetting a Breaker
If a circuit causes the breaker to throw, it is indicated by a flashing
LED. The LED corresponding to the thrown breaker will flash by its switch
along with the stop LED. If the stop LED is the only LED flashing, one of
the un-switched outputs (trim, 12V, radio, auto bilge float switch,
electronics, or key on engine hot) has thrown a breaker. To reset the
breaker, press the switch leaving it held in for five seconds. If the light
remains flashing there is a direct short present. If the light stops flashing,
the breaker has been reset.
53

Advertisement

Table of Contents
loading

Table of Contents