Advertisement
Available languages
Available languages
CLEANING
THE MOTORIZED
BRUSH AND BLOCKAGES
The brush roll may accumulate
debris
such as strings,
hair and fibers. This type of debris
can wrap
around
the brush and diminish
its ability
to clean effectively.
The Easy-Cut
blade
in the Powerhead
housing
will automatically
cut most debris
accumulation
away
from the
brush roll.
Recommended:
After every
use, clean
the brush rol! with the Easy-Cut
system by
stepping
on the button as illustrated
while
the brush roll is spinning.
\
To Remove Brush Roll For Manual Cleaning:
1. Ensure the vacuum is OFF:.
2. Turn unit over to
access the brush roll.
3. Unlock the
brush roll tab
with flat head
screwdriver
or similar tool
as illustrated.
4. Lift the
brush roll out
of the housing.
Clean off debris
and anything
wrapped
around
the brush.
5. Place the
brush rol! into
the housing
by
aligning
the end
to the brush drive
first, then inserting
the other end correctly
into place.
When
installed
correctly,
the brush roll should
spin freely.
6. Lock the brush in
place
by closing
the
tab as illustrated.
To Remove
Hose
Blockages:
1. To clean out the
hose, press the
hose release
tabs,
as illustrated,
and
pull the motorized
brush
powerhead
away
from the main
vacuum
body.
2. Carefully
remove
any
debris
or blockage
from
the inside of the hose.
Reattach
the motorized
brush
powerhead
onto
the vacuum
body.
NOTE:
Do not use scissors or other sharp
objects
to remove
a blockage
from the
hose as these may damage
the hose.
WARN i NG
This product contains the EASY=CUT blade.
Do not touch the blade when performing
motorized
brush maintenance.
EASY=CUT BLADE
= 12 =
Advertisement
