Initial Air Purifier Set-Up - Aprilaire ALLERGY 9550 Manual

Initial Set-up
Let The Freshness Begin
1.
IMPORTANT: For the initial setup, ensure the air purifier is not plugged into an electrical outlet.
2. Remove the front cover of the air purifier by pulling the front panel away from the purifier, as shown in figure A.
3. Remove the Pre-filter by pressing down on the top tabs and pulling back, as shown in figure B.
4. Remove the Filter Cartridge from inside the air purifier, remove its protective plastic bag and recycle or discard it.
5. Place the Filter Cartridge back inside the air purifier so:
a. You can see the words "This Side Out" printed on the top of the Filter Cartridge frame.
b. The fabric tab is facing outward so you can use it to easily remove and replace the Filter Cartridge in the future.
6. Return the Pre-filter by first inserting the 3 tabs on the bottom, then pinching and inserting the 2 tabs on the top
until it snaps into place.
7. Return the front cover panel by inserting the 2 tabs on the bottom and tilting the cover upward to set it in place at
the top. The front cover should be flush with the top of the air purifier.
8. Plug in the air purifier to an electrical outlet to begin air purification.
17