Scotts S2546 Operator's Manual page 5

Checking Tire Pressure
c
CAUTION: Avoid injury. Explosive separation
of a tire and rim parts can cause serious injury
or death:
- Do not attempt to mount a tire without the
proper equipment and experience to perform
the job.
- Always maintain the correct tire pressure. Do
not inflate the tires above the recommended
pressure. Never weld or heat a wheel and tire
assembly. The heat can cause an increase in air
pressure resulting in a tire explosion. Welding
can structurally weaken or deform the wheel.
- When inflating tires, use a clip-on chuck and
extension hose long enough to allow you to
stand to one side and NOT in front of or over
the tire assembly.
- Check tires for low pressure, cuts, bubbles,
damaged rims or missing lug bolts and nuts.
1. Check tires for damage.
2. Check tire pressure with an accurate gauge.
3. Add or remove air, if necessary:
Tire Size
Front: 15-Inch
Rear: 20-Inch
ASSEMBLY
Pressure-kPa (psi)
97 kPa (14 psi)
69 kPa (10 psi)
Assembly - Page 2