QuickStart Guide
Altering Parameters Using Encoders
To change fixture parameters, select either a fixture or group of fixtures (see
the parameter group of the parameter to be changed - [I], [F], [C], or [B]. Repeatedly press the [I], [F], [C], or [B]
button until the toolbar indicates the desired parameters. Alternatively, just click on one of the buttons shown in the
toolbar. Using encoders (as indicated in
Programmer Window is set to Value mode as shown in
Example:
• To change the pan and tilt parameters for Fixture Group 1, select Fixture Group 1.
• Press the [F] (focus parameter) key. The Programmer window will appear and the encoder labels will now read the
selected features of pan and tilt.
• To cycle through the available feature groups (i.e., from Position to Pan/Tilt speed), simply press the feature button
again or press the appropriate button on the IFCB Toolbar.
Note: To quickly toggle through values in 25% steps, just press on the Encoder knob, or touch the Encoder label on
the screen. To alter the attribute values in a finer manner, hold the [SHIFT] key pressed while turning the Encoders.
2 8
Programming
Figure 1 on page
Figure
Figure 38: Programmer - Values Window
500ML Lighting Control Console
"Selecting Fixtures" on page
5), change the parameters as desired. Make sure the
38.
21). Select