How To Operate Display Unit; Display Unit Position; Description Of Display And Button; Field Setting - Fujitsu 30RLXEH Installation Manual

8. HOW TO OPERATE DISPLAY UNIT

8.1. Display unit position

Never touch electrical components such as the terminal blocks except the button on
the display board. It may cause a serious accident such as electric shock.
Once refrigerant charging is completed, be sure to open the valve prior to
performing the field settings. Otherwise, the compressor may fail.
Discharge any static electricity from your body before touching the push buttons.
Never touch any terminal or pattern of any parts on the control board.
• The positions of the buttons on the outdoor unit control board are shown in the figure
below.
• Various settings can be adjusted by changing Push buttons on the board of the outdoor
unit.
• The printed characters for the LED display are shown below.
LED display part
Button part
En-12
WARNING
CAUTION
Inverter cover

8.2. Description of display and button

Display lamp
(1) POWER / MODE Green
(2) ERROR Red
(3) PUMP DOWN
Orange
(L1)
(4) LOW NOISE
MODE Orange
(L2, L3)
(5) PEAK CUT
Orange
(L4, L5, L6)
Button
To switch between "Field setting" and "Error code
SW1 MODE
display".
To switch between the individual "Field settings"
SW2 SELECT
and the "Error code displays".
To fix the individual "Field settings" and the "Error
SW3 ENTER
code displays".
SW4 EXIT To return to "Operation status displays"
SW5 PUMP DOWN To start the pump down operation.

9. FIELD SETTING

Discharge the static electricity from your body before setting up the switches.
Never touch the terminals or the patterns on the parts that are mounted on the
board.
Wall mounted model cannot use this function.

9.1. Field setting buttons

• Remove the front panel of the outdoor unit access the print circuit board of the display
unit.
Print circuit board buttons for various settings and LED displays are shown in the left
figure.
Function or operation method
Lights on while power on. Field setting in
outdoor unit or error code is displayed with
blink.
Blinks during abnormal air conditioner
operation.
Lights on during pump down operation.
Lights on during "Low noise" function when
field setting is activated. (Lighting pattern of L2
and L3 indicates low noise level)
*See page 13.
Lights on during "Peak cut" function when local
setting is activated. (Lighting pattern of L4, L5
and L6 indicates peak cut level)
*See page 13.
Function or operation method
CAUTION