Remove/Replace The Power Supply Assembly; Remove/Replace Receiver Subsystem Pcb (Backplane) - GE ApexPro TT Technical Manual

Remove/replace the power supply assembly

Remove/replace receiver subsystem pcb (backplane)

2001989-351A
5. Fold the retaining clips inward, seating the module into the connector.
NOTE
Do not force the module or retaining clips. If it does not seat easily, the
module may be upside down.
6. Replace the front cover.
Retaining clip
Quad receiver
modules
1. Remove the front cover as described above.
2. Remove 3 screws from the upper rear of the top cover.
3. Remove top cover.
4. Disconnect the power supply harness from the receiver subsystem pcb.
5. Remove 4 screws holding the power supply to the chassis assembly.
6. Remove power supply.
7. Reverse the above steps to install a power supply assembly.
1. Remove the front cover as described above.
2. Remove 3 screws from the upper rear of the top cover.
3. Remove top cover.
ApexPro™
Replaceable parts
Top cover
Chassis front
disassy cover
6-27