1. Program Installation
Program installation procedure consists of the following steps.
When the system is in redundant configuration, perform system changeover by turning OFF the System 0 and repeat
the above steps.
1.1 Off-Line Startup
START
Set the SENS switch for
the system to be initial-
ized (CPU0, CPU1) to
"c" on the EMA card.
• Turn Power-SW ON.
END
Off-Line Startup
HD Initialization
Basic Software Installation
Standard Service Software Installation
<Status change of 7 Segment LED on the EMA card>
ND-70373 (E)
<Startup end (off-line mode)>
SYSTEM STARTUP
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required
CHAPTER 3
Page 19
Revision 1.0