Table of Contents
Advertisement
Caution
Do not operate shaker with an
unbalanced load. Platforms should
be loaded for optimum stability and
operation. Do not lift shaker by the
platform.
Warning
Do not operate the shaker at
speeds that will cause the contents
of vessels to be thrown out.
Platform Installation
1.
Select the appropriate platform for the vessels
to be shaken. A wide variety of platforms and
accessories are available:
• Dedicated platforms have the maximum
number of flask clamps attached for safe oper-
ation.
• Combination platforms allow the user to
shake a wide variety of different sized vessels
on the same platform.
2.
Carefully position the platform horizontally over
the shaker's mounting plate, aligning the 4
mounting holes.
3.
Position one of the thumbscrews provided
through each of the 4-platform mounting holes
and tighten securely.
Flask Clamp Installation
Each flask clamp contains a support spring located at
the narrow top of the clamp.
Depending on the size of the clamp, the clamp base may
contain one or several screws necessary to secure the
clamp to the platform. All screws provided with the
clamp must be properly attached to the platform.
1.
Carefully place the desired vessel in the clamp
by first pulling the clamp spring far enough
apart to enable the flask base to be positioned
inside the clamp. Gently slide the flask into its
proper position securing it to the wider bottom
of the clamp. The spring will hold the neck of
the flask securely in place and provide security
during shaking.
2.
Make sure all vessels are securely clamped
before turning on unit.
Wherever possible, vessels should contain a stopper to
prevent hazardous substances being thrown out during
the mixing action.
U
I
NPACKING AND
NSTALLATION
15
Hide quick links:
Advertisement
Table of Contents
