Use Philips Easylink; Use Edid; Use Timer - Philips 43PFT5853S/98 User Manual

Use Philips EasyLink

With Philips EasyLink you can operate a
connected device with the TV remote control.
EasyLink uses HDMI CEC (Consumer
Electronics Control) to communicate with the
connected devices. Devices must support
HDMI CEC and must be connected with an
HDMI connection.
To enable Philips EasyLink, you need to:

Compatible device can work normally.

Switch to EasyLink.
Note

The EasyLink compatible device must be
turned on and selected as a source.

Philips doesn't ensure 100%
interoperability with all HDMI-CEC
devices.
Turn on or off EasyLink
Note

Do not enable Philips EasyLink if you
don't intend to use it.
1. Press key.
2. Select TV Settings > EasyLink > EasyLink.
3. Select OFF or ON and then press OK key.
Set HDMI-Audio Output
1. Press key.
2. Select TV Settings > EasyLink > HDMI –
Audio Output.
3. Select OFF or ON and then press OK key.

Use EDID

1. Press
2. Select TV Settings > EDID Version and
then press OK key to enter.
3. Select your needed version and then press
OK key to confirm.
Tip

EDID is a data structure provided by a
digital display to describe its capabilities
to a video source.This settings is valid
only under HDMI source.

Use Timer

You can use Timer so as to switch the TV to
standby after the specified time.
Use Sleep Timer
Set the time when the TV is switched to standby.
Tip

You can switch off the TV or reset the
Sleep Timer before the timer reaches
zero.
1. Press
Sleep Timer.The Sleep Timer is shown on
the screen.
2. Set the timer to a value between 0 to 240
minutes.The increment of the Sleep Timer is
10 minutes. If the Sleep Timer is set to 0, it
will be turned off.
3.
Press OK key to turn on the Timer.The TV is
switched to standby when reaching the
preset time.
EN 12
key.
key and then select TV Settings >