Sanyo PLC-SU51 Owner's Manual page 55

Some displays are not seen
during the Operation.
PIN code dialog box appears at start-up. – PIN code lock is being set. Input a PIN code (1234 or numbers you have
Computer 2 cannot be selected.
The Terminal item cannot be selected.
The Remote Control does not work.
Wireless Mouse function does not work. – Make sure your computer is connected to the projector with a USB cable.
WARNING :
High voltages are used to operate this projector. Do not attempt to open the cabinet.
If problems still persist after following all operating instructions, contact the dealer where you purchased the projector or the
service center. Give the model number and explain about the problem. We will advise you how to obtain service.
The CE Mark is a Directive conformity
mark of the European Community (EC).
– Check the Display item. (See "Setting" on page 43.)
set). (See "PIN code lock" on page 20 and 47.)
– Select Computer 2 at the Terminal item in the Setting Menu. (See "Setting"
on page 44.)
– The Terminal item in the Setting Menu cannot be selected after Computer 2
is selected. Select other input source such as Computer 1 or Video with the
INPUT button on the top control, the COMPUTER button or the VIDEO
button on the remote control so that the Terminal item can be selected.
– Check the batteries.
– Make sure no obstruction is between the projector and remote control.
– Make sure you are not too far from the projector when using the remote
control. Maximum operating range is 16.4' (5m).
– Make sure the code of the remote control is conformed to the projector.
(See page 14 and 46.)
– Unlock Key lock for the remote control in the Setting Menu. (See page 46.)
(See page 17.)
– Check cable connection between the projector and your computer.
(See page 17.)
This symbol on the nameplate means the product is
Listed by Underwriters Laboratories Inc. It is designed
and manufactured to meet rigid U.L. safety standards
against risk of fire, casualty and electrical hazards.
Appendix
55