Serial Control Interface - Sanyo PLC PLC-XP100BKL Owner's Manual

Appendix

Serial Control Interface

This projector provides a function to control and monitor the projector's operations by using the RS-232C serial
port.
Operation
1
Connect a RS-232C serial cross cable to CONTROL
PORT on the projector and serial port on the PC.
(See p.20)
2
Launch a communication software provided with PC
and setup the communication condition as follows:
Baud rate
Parity check
Stop bit
Flow control
Data bit
✔ Note:
• The default of the baud rate is set to 19200 bps. If an
error occurs in the communication, change the serial
port and the communication speed (baud rate).
3
Type the command for controlling the projector and
then enter the "Enter" key.
Example
When you want to change the input to INPUT 2, Type
'C' '0' '6' 'Enter'.
✔ Note:
• Enter with ASCII 64-byte capital characters and one-
byte characters.
78
: 9600 / 19200 bps
: none
: 1
: none
: 8