Replacing Consumable Parts; Replacing The Filters - Sanyo PDG-DXT10KL User Manual

Replacing Consumable Parts

During the course of normal usage, consumable parts become worn out resulting in reduced performance. The following
guides detail how to replace the various consumable parts within the projector quickly and safely.
Before replacing any of the parts, please take note of the following:
Ensure that the projector is turned off and disconnected from the power supply.
Ensure that the projector is in a clean, stable position before replacing parts.
Allow at least one hour after shutdown for the projector to cool before attempting replacing any consumable parts.
Do not interchange Lamp 1 and Lamp 2 after the projector has been used onc
Doing so will not allow the projector to display the correct lamp usage hours.
A minimum space is required for replacement. See page

Replacing the Filters

When the lamps are replaced, the filters should also be replaced, not cleaned.
Refer to the following guide to replace the filters.
CAUTION
Do not drop the projector on your h
could injure your hand or fingers.
Note:
The filters on the side and the rear are located on the bottom.
1.
Gently slide the filter covers in the di-
rection shown.
2.
Lift the foam from all three filters in
the direction shown. Remove com
pletely fr
discard.
om the filter cover and
24 and 98
and or fingers while lifting the projector to replace the filters. Doing so
-
97
e.
for more details.
6. Maintenance