Installation And Network Configuration; Mounting - Sanyo POA-MD13NET2 Owner's Manual

Chapter 2 Installation
x Installation and Network configuration

Mounting

1
Turn the Mains switch off.
2
Remove 2 screws on a board
from any of the slots 1 to 4*,
and then pull the board out from
the projector.
* The number of the slots may
differ from the actual depend-
ing on type of the projector.
3
Put the Board into the board slot
along the guide. Mount the
board connector into the socket
in the slot firmly.
4
Secure the board with two screws
(supplied).
Caution
!
Mains switch must be turned off when mounting or removing this product otherwise it may
damage the product.
Do not install multiple network boards into a projector otherwise it may damage the product.
Do not connect the AC cord until after connecting the LAN cable and computer.
14
Mains Switch
Guide
* Mounting example of the 4 slots model.