Positioning The Lcd Hdtv; Stand Removal/Stand Assembly; Wall Mounting; Getting Started - Sanyo DP47840 Owner's Manual

47" 1080p hdtv lcd
Hide thumbs Also See for DP47840:
Table of Contents

Advertisement

Available languages

Available languages

POSITIONING THE HDTV
Always use a firm and flat surface when
positioning your HDTV.
Do not position the unit in a confined area.
Allow adequate space for proper ventilation.
Do not position the HDTV where it is easily
reachable by small children and may present
risk of injury.
STAND REMOVAL ____________
1
Place HDTV face down on a padded or
cushioned flat surface to protect the screen
and finish
2
Remove the four (4) screws securing the foot
stand. CAUTION: Hold the stand firmly as you
remove the last screw.
STAND ASSEMBLY ___________
1
Place HDTV face down on a padded or
cushioned flat surface to protect the screen
and finish
2
Carefully insert the stand base to the bottom
of the HDTV and secure the base by inserting
4 screws as indicated in the above diagram.
NOTE: If your HDTV came packed with the Stand Base
unassembled, these screws will be found in the
literature package.

WALL MOUNTING ____________

Wall mounting of the HDTV must be performed
by a skilled person.
Use the screws you would use to attach the stand
base to secure the HDTV to a wall mounting kit
(not included.)
VESA standard interface: 400 x 400
Mounting screws measurements:
M6 (6mm) Diameter, Length—12mm (maximum)

GETTING STARTED

BATTERY INSTALLATION
Install two (2) "AAA" batteries in the remote
control. (Not included)
To ensure safe operation, please observe the
following precautions:
• Replace both batteries at the same time. Do not use a
new battery with a used battery.
• There's a risk of explosion if a battery is replaced by
an incorrect type.
• Do not expose the Remote Control unit to moisture
or heat.
• Be sure to match the "+" and "
batteries with marks inside the remote control.
ANTENNA CONNECTION FOR
OFF-AIR SIGNALS OR CABLE
Hook up your antenna or your cable service to
the HDTV's ANT terminal with the use of a 75
OHM coaxial cable.
NOTE: Keep your indoor antenna at least 3 ft. away
from the television set and any other electronic
equipment.
ANTENNA
CABLE
The tuner in this HDTV can receive:
• Digital and Analog off air signals from an antenna
• Analog or ClearQAM cable channels from a direct
Cable TV connection.
www.sanyoctv.com
Need help?
" signs on the
ANALOG / DIGITAL
ANTENNA IN
5
1-800-877-5032

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents