Storing A Number In The Directory; Replacing A Directory Entry With A Caller Id Entry; Changing A Stored Number; Making Calls From The Directory - Sanyo CLT-U12 Instruction Manual

DIRECTORY
7. Use the digit keys to enter the desired telephone number. If you make a
mistake, press CH/DEL to delete previous digits one by one, then enter the
correct digits. If you wish to add a pause, press PAUSE two times at the
desired location. Be sure to press it twice, or you will enter a # (number sign)
and not a pause. Each pause counts as 1 digit in the dialing sequence. Or
you can store redial number in the directory by pressing REDIAL (Note: If the
redial number is longer than 24 digits, it cannot be stored into the memory.).
8. Press MEM again to store the number to memory. If you are replacing a
number, "REPLACE MEMO?" shows on screen. Press MEM again to confirm,
or press *TONE/EXIT to return to standby mode.
To view your directory, press MEM and use CID/VOL
(0-9) to scroll.

Replacing a directory entry with a Caller ID entry

Use the same procedure as for storing Caller ID entries in the directory

Changing a stored number

Use the same procedure as for storing a number in the directory

Making calls from the directory

1. Make sure the phone is ON by pressing TALK.
2. Press MEM.
3. Press the number (0 - 9) for the desired memory location. The number dials
automatically.
Or:
1. Make sure the phone is OFF (not in TALK mode).
2. Press MEM.
3. Press the number (0-9) or use CID/VOL
number.
4. Press TALK, the number will be dialed automatically.

Reviewing and deleting directory contents

1. Make sure the phone is OFF (not in TALK mode).
2. Press MEM.
3. Use CID/VOL or
or
to scroll through the directory until the desired name/
20
or or the number
to select the desired