Advertisement
DELAY SETUP
To establish the proper delay, it is recommended that the Delay
control is set at half way (12 o'clock). This is approximately a delay
of 10 to 15 seconds. With both AMP A and AMP B connected.
Turn on both sources. The audio from AMP B will be hjeard from
the speakers. Turn off AMP B and time the delay to when AMP A is
heard. To increase the time delay rotate the DELAY control
clockwise, to decrease the delay rotate the control counter
clockwise. Repeat these steps until the desired delay is achieved.
SENSITIVITY SETUP
Set the trigger control approximately half
way (12 o'clock). Play AMP B,
monitoring the volume level;
lower the volume level of AMP B
to the minimum level required to
maintain the signal on the AB-3.
Remember AMP B is the primary
source. The volume adjustment
will be made from AMP B. Allow
the audio to play for a minute to
determine if this level will keep
the AB-3 selected to your local source. If the volume level that you
have chosen is not enough to keep the AB-3 selected, increase the
sensitivity (TRIGGER) adjustments by rotating the control
clockwise. Make these adjustments with a slight rotation. Try to
avoid rotating the control too much. If the sensitivity adjustment is
set too sensitive the AB-3 could randomly switch. If this occurs
Minimum trigger level: 15 mV
Delay: 0 to 30 Seconds
Power Handling: 200 Watts RMS continuous per channel
Power: 12 VDC 200 mA. Included
Dimensions: 6.25" x 3.75" x 2.50"
158mm x 95mm x 64mm
Weight: 1.4lb (.65kg)
TV W/ SPEAKER OUTPUTS
TV W/ VARIABLE OUTPUTS
If your TV has speaker outputs,
If your TV does not have external
connect them to the AMP B input
speaker outputs, connect your TV's
on the AB-3.
variable out to an amplifier then to
AMP B on the AB-3.
TV W/O VARIABLE OUTPUTS
If your TV only has RCA outputs,
connect your TV to a receiver /
integrated amplifier. Connect the
receiver/amplifier outputs to the
AMP B input on the AB-3
Advertisement
