Table of Contents
Advertisement
Setting the Audible End of Line Signal (Set Bell)
To set the "end of line" signal:
1. Position the cursor in the desired column.
2. Press the asterisk (*) key.
An asterisk symbol is displayed in the column position that you chose.
You can set the "end of line" signal at any column, including margin and tab stop
positions. This causes the audible alarm to sound as the cursor enters that column
position.
Note: To use the "end of line" signal, you must have the audible alarm feature.
Clearing Tab Stops and Audible End of Line Signals
To clear a tab stop or the audible "end of line" signal setting:
1. Position the cursor at the tab stop or at the "end of line" signal setting.
2. Press the Delete Character key.
If both a tab stop and the "end of line" signal are set in the same position, both are
cleared.
Clearing All the Tab Stops
To clear all the tab stops:
Press the CLEAR key.
The scale line is updated accordingly.
Changing the Scale Line Origin
To change the scale line origin:
1. Place the cursor at the first scale line position.
2. Press the Cursor Select key.
The origin changes from 0 to 1, or from 1 to 0. Only the scale lines numbering will
change; the margins, tabs, and "end of line" signal position will notchange.
Entry Assist Parameters
Thefollowing Entry Assist parameters remain in effect during entryto and exit
from document mode unlesstheyare changed by the operatoror the power is
turned off:
• Margin settings and types
• Tab stop settings
• Audible line-ending signal position
• Word wrap status
• Scale line origin.
In addition, APL mode and insert mode states remain In effect during entry to and
exit from change format mode.
16
Entry Assist User's Guide
Advertisement
Table of Contents
