Installation Manual
Quidway Eudemon 200 Firewall
3.1 Installation Flow
Mount the cabinet (optional)
Mount the equipment to
the specified location
Connect the PGND wire
Connect the power cord
Connect the equipment
to the console terminal
to the console terminal
Install interface module
Connect the equipment
Connect the equipment
Verify installation
Power on the equipment
Figure 3-1 Installation flow
Caution:
Before installing a Eudemon200 firewall, make sure that:
You have read Chapter 2 Installation Preparation carefully.
The requirements described in Chapter 2 Installation Preparation have been met.
Chapter 3 Installation
Start
Start
to Ethernet
to WAN
NO
NO
Normal ?
YES
End
End
Troubleshooting
Turn off the
power switch
3-1
Chapter 3 Installation