Table of Contents
Advertisement
TROUBLESHOOTING GUIDE
SYMPTOM
No power
• Poor plug
even when
connection
STANDBY is
set to "ON"
Will not work
• iPod
with iPod
properly
®
• iPod
selected
No sound
• Improper volume
level
• Speaker Set power
off
• System failure
(require code
matching)
IPB125 HJ580SA eng 09.indd 9
CAUSE
• Insert AC power plug firmly into AC outlet.
• Choose correct insert and dock into system again.
is not docked
®
• Choose iPod
input not
®
• Make sure that volume controls are set properly.
• Turn the power switch to ON from Speaker Set.
• Press and hold the On/Off button of Base unit
and plug in the mains power at the same time.
The transmitter's AUX LED light from base unit
starts flashing, it represents the transmitter is set
at "match code mode" and ready to send code to
speaker.
• At Speaker side, use a sharp pencil or similar thing
to press "match code button" for about 2 seconds,
this button is located at the bottom of speaker
receiver, then the receiver LED light starts flashing,
the receiver is now also entering to the "match
code mode". When the match code has been done
successfully, the receiver's LED light will stop
flashing. If no code is received from based unit, 30
sec later, it will exit to Standby mode.
• When matching code process is done, press
the On/Off button of base unit again to exit.
If this button not pressed, there will also exit
automatically after 60 seconds.
ACTION
mode using the FUNCTION button.
®
9
2009/4/20 11::06 AM
Advertisement
Table of Contents
