Internal Mounting, Continued
Figure 4. EFL Reset Button Relief Hole.
CAUTION:
Exceeding the specified mounting screw
torque may damage the housings.
External Mounting
For external mounting, make a 1-3/8-inch (35 mm)
diameter hole in the duct wall or damper sleeve. The
sensor will protrude into the duct or damper for proper
temperature sensing.
Siemens Industry, Inc.
Figure 5. Providing Proper Sensor Temperature
Detection Access.
CAUTION:
Exceeding the specified mounting screw
torque may damage the housings.
Document No. A6V11200850
Installation Instructions
May 1, 2018
3 of 4
Page